(Operation Display) indicator
Tip
To prevent miss-operation press once to display a confirmation message.
When pressing once more the power will be switched off.
You can also press twice successively.
After getting accustomed you can try this operation.
Turning Off
the Projector
Turn off the power for the equipment connected
to the projector.
Adjustment /
Turning Off the Projector
When a message for confirmation is
displayed, press a button other than
to turn the message off. The previous
condition will be restored.
The indicator will start flashing orange. (Cool-down in progress/approx. 2 minutes)
After the indicator lights orange steadily you can
disconnect the power cord.
If the power cord is disconnected while the indicator is still flashing orange,
it may cause problems with projector operation.
*Do not forget to set the R/C switch of the remote control to the OFF position.
Press the twice to turn off the projector's power.
Pages 31, 32 of
Instruction Manual
Tip
If the images have keystone distortion ...
Press , on the projector's control panel to correct the keystone distortion.
A keystone correction reduces screen
size.
The keystone correction is stored in
memory. You will need to readjust the
image if the projector is moved to a
different location or the projection angle is
changed.
If the images become uneven in
appearance after keystone correction is
carried out, decrease the Sharpness
setting.
Keystone Correction
Page 29 of Instruction Manual
When the bottom is
too wide
When the top is
too wide
Adjustment
To Next Page
Loading...
Need help?
General
