Connecting to a Computer
■ ■ ■ ■ ■ ■
9
1. Connect the 9-pin end of the PS/ 2 mouse cable or, the
U SB mouse cable to the Mouse/ Com or U SB mouse port
on the projector.
2. Disconnect your mouse from the mouse port on the back
of your computer and replace it with the other end of the
PS/ 2 mouse cable or U SB mouse cable. (Your computer’s
mouse will be disabled while you are using the remote
control as a mouse.)
Connecting the Audio Cable
1. If you will be using audio, connect one end of the audio
cable to the Audio In jack on the projector.
2. Connect the other end of the audio cable to the speaker or
audio out port on the computer’s sound card.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
