■ ■ ■ ■
58
Replacing the Lamp
Replace the lamp when:
• The projected image gets darker or starts to deteriorate.
• The projection lamp indicator is flashing orange .
• The message “LAMP REPLACE” appears on the screen
when the projector lamp comes on.
♦
Note:
To keep the initial brightness and image quality, replace
the lamp as soon as possible when the m essage appears on the
screen. The replacement message is set to being displayed at about
2000 hours of use. Contact your local EPSON dealer for a spare
lamp. R equest part number ELPLP10B (EMP-700/ 500) or
ELPLP10S (EMP-710).
♦
Warning:
Let the lam p cool before replacing it. A lso, do not
touch the glass portion of the lam p assem bly. Touching the glass
portion of the lamp will result in premature lamp failure.
1. Turn off the power and allow the unit to cool down, then
remove the power cord.
The amount of time needed to cool down will depend on
the ambient temperature.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
