Connect the video equipment.
Remove the lens cover.
Attach the power cable to the projector.
Insert the power plug into a wall socket.
The power indicator lights orange.
Turn on the power of the video equipment.
If connected to a video source, start playback.
Press the [Power] button.
The projector beeps and the power supply indicator begins to
blink green.
Wait until the power indicator lights green.
It takes about 40 seconds.
Select the images to be projected.
* Switching between Input A RGB-Video and Component Video is
carried out in the “Setting” → “Input Signal” → “Input A”
configuration menu.
When set to Component Video, the projector automatically
determines whether a YCbCr or YPbPr signal is being input.
Turn off the power to the video equipment.
Press the [Power] button.
A confirmation screen is displayed.
Press the [Power] button again.
The power indicator begins to blink.
Wait until the power indicator lights orange and the
projector beeps twice.
Cool-down takes place. It takes about 20 seconds.
Unplug the projector from the outlet.
c
Turn off the power of the projector and the equipment you are connecting to.
Turning on the Projector
1
2
4
3
5
Play!
6
Power indicator
Selecting the Input Source
Projector Remote control
The input source changes whenever
the [Source] button is pressed.
The input source changes whenever
the [Input A/B] button is pressed.
The input source changes whenever the
[S-Video/Video] button is pressed.
p
If two or more sources are connected, be sure to swap the
audio cables between the connected equipment, when
necessary.
Turning off the Projector
p
The confirmation screen disappears if anything other than
the [Power] button is pressed, or if nothing is pressed for 7
seconds.
c
Do not remove the plug while the power indicator is blinking,
or this may damage the projector.
To Next Page
Loading...
