Epson ET-14000 - Select Paper Path PP 03 H 00 H 00 H M1 M2

2016/08/25
Revision: 2 Page: 70
6.1.10 Select paper path “PP” 03H 00H 00H m1 m2
[Format]
“PP” 03H 00H 00H m1 m2
[Parameters]
The parameter “m1” and “m2” are each one byte binary data.
The “m1” describes paper is continuous type or a single sheet in CSF or a manual inserted sheet as shown
below.
Paper m1 m2
Cut Sheet Rear 01H FFH
[Function]
Select paper path to be used for the temporary default.
The previous setting will be kept if the parameter “m1” and “m2” exceeds its limit.
Also, this command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.