Epson ET-2815 - Page 151

❏ e wireless router is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the wireless router.
Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the wireless
router.
1.
Hold down the [WPS] button on the wireless router until the security light ashes.
If you do not know where the [WPS] button is, or there are no buttons on the wireless router, see the
documentation provided with your wireless router for details.
2.
Hold down the
button on the printer for at least ve seconds until the light and the light ash
alternately.
e connection setting will start. When a connection is established, the
light turns on.
Note:
e printer is in a connection error status when the
light and the light ash simultaneously. Aer clearing
the printer error by pressing the
button on the printer, reboot the wireless router, place it close to the printer and try
again. If it still does not work, print a network connection report and check the solution.
Related Information
& “Checking the Network Connection Status” on page 154
& “Printing a Network Connection Report” on page 155
Adding or Replacing the Computer or Devices > Re-setting the Network Connection > Making Wi- …
151