2018/2/26
Revision: 1 Page: 76
6.1.10 Select paper path “PP” 03H 00H 00H m1 m2
[Format]
“PP” 03H 00H 00H m1 m2
[Parameters]
The parameter “m1” and “m2” are each one byte binary data.
The “m1” describes paper is continuous type or a single sheet in CSF or a manual inserted sheet as shown
below.
Paper path m1 m2
Rear ASF 01H 00H
Cut Sheet Upper Front 01H 01H
Cut Sheet Lower Front 01H 02H
Upper then Lower Front 01H FDH
Auto Select *1 01H FFH
CD-R 02H 01H
[Function]
Select paper path to be used for the temporary default.
The previous setting will be kept if the parameter “m1” and “m2” exceeds its limit.
Also, this command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.
*1:
If the paper handling function is Enabled by the panel, a feeding path is automatically selected Upper Front,
Lower Front or Rear ASF by the paper size and type.
If the paper handling function is Disabled by the panel, a feeding path is automatically selected Upper Front,
Lower Front or Rear ASF by the paper size. Paper type is not considered.
The order of the paper path selection:
1. Upper Front
2. Lower Front
3. Rear ASF
To Next Page
Loading...
