3. Turn the printer on while holding the
y
button down, and then release the buttons when the power light
ashes.
e nozzle check pattern is printed.
Note:
It may take some time to start printing the nozzle check pattern.
4. Examine the printed pattern.
❏ If you cannot see any broken lines or missing segments as in the following "OK" pattern, the nozzles are not
clogged. Print head cleaning is not necessary.
❏ If there are broken lines or missing segments as shown in the "NG" pattern, the print head nozzles may be
clogged. Go to the next step.
5. Hold the
y
button down for ve seconds until the power light starts ashing.
Print head cleaning starts.
Note:
It may take some time to start print head cleaning.
6.
When the power light stops ashing, print a nozzle check pattern again. Repeat cleaning and printing the
pattern until all lines are printed completely.
User's Guide
Maintaining the Printer
92
To Next Page
Loading...
