Options 29
R
R4CA100
Setup Guide Rev. D
SETUP.FM A5 size
12/9/03
Proof Sign-off:
KOW M. Tago K. Yoda
T. Takahashi
NOC K. Lee
System requirements
Installing the IEEE 1394 Scanner I/F Card in your
scanner
To use your scanner as an IEEE 1394 device, you need to install
the optional IEEE 1394 Scanner I/F Card.
1. Turn off the scanner. Unplug any power cords, then
disconnect all cables from the back panel of your scanner.
2. Remove the two screws using a cross-head screwdriver and
the plate. Be sure to keep both screws; you may need to use
them again if you re-install the shield plate.
Hardware: PC with built-in IEEE 1394 OHCI Host Controller
supported by Microsoft
®
, or PC with IEEE 1394
PCI board installed
OS: Microsoft
®
Windows
®
XP, 2000 Professional, or
Me pre-installed with IEEE 1394 OHCI port
To Next Page
Loading...
