2 Safety Instructions
L
R4CA100
Setup Guide Rev. D
SETUP.FM A5 size
12/9/03
Proof Sign-off:
KOW M. Tago K. Yoda
T. Takahashi
NOC K. Lee
❏ Except as specifically explained in this Setup Guide and the
Online Reference Guide, do not attempt to service the scanner
yourself.
❏ Unplug the scanner and refer servicing to qualified service
personnel under the following conditions:
❏ If the power cord or plug is damaged.
❏ If liquid has entered the scanner.
❏ If the scanner has been dropped or the case damaged.
❏ If the scanner does not operate normally or exhibits a
distinct change in performance. (Do not adjust controls
that are not covered by the operating instructions.)
❏ For United Kingdom, Hong Kong and Singapore uses:
Replace fuses only with fuses of the correct size and rating.
❏ If you plan to use the scanner in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this scanner, the building
installation must be protected by a 10 or 16 Amp circuit
breaker.
Note for German-speaking users:
Bei Anschluss des Scanners an die Stromversorgung muss
sichergestellt werden, dass die Gebäudeinstallation mit einer
10A- oder 16 A-Sicherung abgesichert ist.
To Next Page
Loading...
