❏ The power-supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not
place objects on top of the power-supply cords and do not allow the power-supply cords to be stepped on or
run over. Be particularly careful to keep all the power-supply cords straight at the ends and the points where
they enter and leave the transformer.
❏ If you use an extension cord with the product, make sure that the total ampere rating of the devices plugged
into the extension cord does not exceed the cord’s ampere rating. Also, make sure that the total ampere rating
of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere rating.
❏ If you plan to use the product in Germany, the building installation must be protected by a 10 or 16 amp
circuit breaker to provide adequate short-circuit protection and over-current protection for the product.
❏ When connecting the product to a computer or other device with a cable, ensure the correct orientation of the
connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation
may damage both devices connected by the cable.
❏ Place the product on a flat, stable surface that extends beyond the base of the product in all directions. If you
place the product by the wall, leave more than 10 cm between the back of the product and the wall. The
product will not operate properly if it is tilted at an angle.
❏ When storing or transporting the product, avoid tilting it, placing it vertically, or turning it upside down;
otherwise ink may leak.
❏ Allow spaces behind the product for the cables, and space above the product so that you can fully raise the
printer cover.
❏ Avoid places subject to rapid changes in temperature and humidity. Also, keep the product away from direct
sunlight, strong light, or heat sources.
❏ Do not insert objects through the slots in the product.
❏ Do not put your hand inside the product during printing.
❏ Do not touch the white flat cable and ink tubes inside the product.
❏ Do not use aerosol products that contain flammable gases inside or around the product. Doing so may cause
fire.
❏ Do not move the print head by hand; otherwise, you may damage the product.
❏ Always turn the product off using the P button. Do not unplug the product or turn off the power at the outlet
until the P light stops flashing.
❏ Before transporting the product, make sure that the print head is in the home (far right) position.
❏ If any of the ink tanks are not filled up to the lower line, refill the ink soon. Continued use of the product
when the ink level is below the lower line on the tanks could damage the product.
❏ If you are not going to use the product for a long period, be sure to unplug the power cord from the electrical
outlet.
Handling ink
We will provide ink-related safety instructions and product advice/warnings in the linked section.
User’s Guide
Important Instructions
8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
