Transporting the
Product
If you move the product some distance, you need to
prepare it for transportation in its original box or one of
a similar size.
c
Important:
❏ When storing or transporting the product,
avoid tilting it, placing it vertically, or turning
it upside down; otherwise ink may leak.
❏ When storing or transporting an ink bottle
after removing its seal, do not tilt the bottle and
do not subject it to impacts or temperature
changes. Otherwise, ink may leak even if the
cap on the ink bottle is tightened securely. Be
sure to keep the ink bottle upright when
tightening the cap, and take measures to
prevent ink from leaking when you transport
the bottle.
A
Remove all paper from the rear paper feed and
make sure the product is off.
B
Close the paper support and the output tray.
C
Open the scanner unit and make sure the print
head is in the home position on the right.
Note:
If the print head is not in the home position on the right,
turn on the product and wait until the print head locks in
the far right position. Then turn off the product.
D
Unplug the power cord from the outlet, then
disconnect all cables from the product.
E
Secure the print head to the case with tape as
shown, then close the scanner unit.
Note:
Do not place tape on the white flat cable inside the
product.
F
Set the transportation lock to the locked
(Transporting) position.
G
Unhook the ink tank unit from the product and
lay it down, and then make sure to install the cap
onto the ink tank securely.
English
Basic Guide
Transporting the Product
15
To Next Page
Loading...
Need help?
General
Weight and Dimensions
