EasyManuals Logo

Epson L8180 User Manual

Epson L8180
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #277 background imageLoading...
Page #277 background image
277
• Print a network status sheet and verify that the network settings are correct. If the network status is
Disconnected, check any cable connections and turn your product off and then on again.
• Print a network connection report and check the codes and messages on the report to help determine
the cause of the problem.
• If you are using TCP/IP, make sure the product's IP address is set correctly for your network. If your
network does not assign IP addresses using DHCP, set the IP address manually.
• Make sure your computer and product are both using the same wireless network.
• If network printing is slow, print a network status sheet and check the signal strength. If it is poor, place
your product closer to your router or access point. Avoid placing your product near a microwave oven,
cordless phone, or large metal object, such as a filing cabinet.
Note: If you are using a 5 GHz wireless router, set the router to operate in dual band (2.4 GHz and
5 GHz) mode. If your router uses a single network name (SSID) for both the 2.4 GHz and 5 GHz band,
give each band its own network name (SSID) instead, such as Home Network 2.4 GHz and Home
Network 5 GHz. See your router documentation or contact your internet service provider for
instructions.
• Try restarting your router following the instructions in your router documentation.
Note: If you are reading these instructions online, you will lose your Internet connection when you
restart your router.
• Check to see if your wireless router or access point has an enabled Privacy Separator function that is
preventing printing from a device over the network. See your router or access point documentation for
instructions on disabling the Privacy Separator function.
• If you are connecting the product wirelessly via EpsonNet Setup and the Wi-Fi connection icon is not
lit or does not appear on the product's LCD screen, make sure your product software was installed
correctly. If necessary, reinstall your software.
Parent topic: Solving Network Problems
Related concepts
Uninstall Your Product Software
Related tasks
Printing a Network Status Sheet
Printing a Network Connection Report

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson L8180 and is the answer not in the manual?

Epson L8180 Specifications

General IconGeneral
Print TechnologyInkjet
Maximum Print Resolution5760 x 1440 dpi
Ink TypeDye-based
Number of Ink Colors6
ConnectivityUSB, Wi-Fi, Ethernet
FunctionsPrint, Copy, Scan
Memory Card CompatibilitySD, SDHC, SDXC
Ink Tank SystemYes
Paper Sizes SupportedA4, A5, A6, B5, Letter, Legal, 10 x 15 cm, 13 x 18 cm, 16:9
Duplex PrintingYes
Scanner TypeFlatbed
Display4.3-inch Color LCD
Printing Speed ISO/IEC 2473416 ppm (black), 12 ppm (color)
Scanning Resolution1200 x 4800 dpi
Print Speed (Black)16 ppm
Print Speed (Color)12 ppm
Ink Cartridge Configuration6 individual ink tanks
Paper Capacity100 sheets

Related product manuals