Epson Labelworks LW-Z700 - Attaching Label; Turning the Power off

15
Top
Safety Instructions
Specications
Troubleshooting
Part Names and
Functions
Start Here
Cleaning
Initializing the
Settings
Purpose-based Index
Key Menu Index
Frame and Table Lists
Start Here
CAUTION
Depending on the environment where you use labels and
the nature of the adhered surface, the labels may be peeled
or discoloured, and the adhesive may remain on or damage
the adhered surface. Be sure to check the environment and
the nature of the adhered surface before use. Epson takes
no responsibility for any damage or loss due to the above
mentioned causes.
6. Attaching label
1. Peel o the backing paper.
2. Attach the label and rub it rmly.
7. Turning the Power O
1. Press .
The characters you have entered in the current session
are stored even after the printer is turned o. They are
displayed when it is turned on again.
2. Open the battery cover and then remove the
Li-ion battery.
If the AC adapter is connected, disconnect the AC
adapter from the printer.
CAUTION
• "Powering o." is displayed while turning o this printer.
Do not remove the Li-ion battery or disconnect the AC
adapter until this message disappears.
• When you don't use the printer for a long period of time,
remove the batteries (Li-ion battery or alkaline batteries),
disconnect the AC adapter, and remove the tape cartridge
from the printer.