Epson Labelworks LW-Z900 - Changing the Printer Settings; Cutting and Quality Settings

36
Top
Safety Instructions
Specications
Troubleshooting
Part Names and
Functions
Start Here
Cleaning
Initializing the
Settings
Purpose-based Index
Key Menu Index
Frame and Table Lists
Changing the Printer Settings +
Auto cut
Auto cut:
Sets whether or not to cut automatically.
Half cut:
When "Auto cut" is set to "On", the function "Half cut" for
precutting just the label part to make the backing paper
easy to peel o can be set.
Print density
Sets the print density.
Drop stop
This function is useful for axing consecutively printed
labels one at a time.
Select "On" to avoid a printed label from dropping. A printed
label stays at the tape eject slot.
When printing multiple copies, printing of the second or
later labels starts each time you remove a printed label.
This function is only available when the label length is
28mm or more, "Auto cut" is set to "On", and "Half cut" is set
to "O ".
Print Speed
Sets the print speed.
Die-Cut pos
Adjusts the text position of die cut label.
Width pos: Adjusts the vertical positioning of text.
Length pos: Adjusts the horizontal positioning of text.
Backlight
Sets the display backlight to On or O.
Language
You can select the language shown on the display from the
following:
Dansk, Deutsch, English, Español, Français, Italiano, Nederlands,
Norsk, Português-Br, Português-EU, Suomi, Svenska, Türkçe
inch:cm
The unit of length used to indicate the label size can be
switched between inch and cm.
Procedure for setting
1. Press + .
2. Select the desired function with
/ and
press
.
3. Select the desired item with
/ and press .