Epson LQ-680 Setup Guide

Proof Sign-off:
H.Kimura CRE Nakano
H.Kimura
XXXXX
LQ-680/LQ-680Pro
Rev. C
SETUP.fm A2 size
12/6/02
Unpacking the Printer
Unpacking the Printer Unpacking the Printer
Unpacking the Printer
Remove the protective materials
Follow the directions on the Notice Sheet to remove the protective materials.
Save all packing and protective materials in case you need to ship the printer in the
future.
Assembling the Printer
Assembling the Printer Assembling the Printer
Assembling the Printer
1. Make sure the printer is turned off and unplugged.
2. Attach the paper guide.
3. Open the printer cover.
4. The print head should be in the replacement position indicated by an indentation
in the front metal plate, as shown below.
5. Turn the ribbon-tightening knob on the ribbon cartridge in the direction of the arrow
to take up any slack in the ribbon.
6. Hold the ribbon cartridge with the exposed ribbon down and the ribbon-tightening
knob facing you, and guide the ribbon under the print head. Then snap the
cartridge into place so that the tabs on both sides of the cartridge fit into the
notches in the cartridge holder.
7. Hold the ribbon cartridge by its handle and push it firmly down into position; then
press on both ends of the cartridge to make sure the plastic hooks fit into the slots.
8. Turn the ribbon-tightening knob again to remove any slack in the ribbon and to
make sure the ribbon moves freely.
9. Close the printer cover.
Connecting the Printer to Your Computer
Connecting the Printer to Your Computer Connecting the Printer to Your Computer
Connecting the Printer to Your Computer
Connecting the printer
Make sure both the printer and computer are turned off, then connect the interface
into the printer and computer.
Plugging in the printer
1. Make sure the printer is turned off.
2. If the power code is not attached to the printer, plug the appropriate end into the
AC inlet on the back of the printer.
3. Plug the power code into a properly grounded electrical outlet.
printer
power cord
ribbon cartridge
Notice sheet
paper guide
Software CD-ROM Setup Guide
Setup
24-pin Dot Matrix Printer
c
Cautions must be observed to avoid damage
to your equipment.
Notes contain important information and useful tips on
the operation of your printer.
4041764 Rev.0
1-F BK
4041764 Rev.0
1-F F43
4041764-00
xxx
Cautions and Notes

Epson LQ-680 Specifications

General

Print Method	Impact dot matrix
Number of Pins	24 pins
Print Resolution	360 x 360 dpi
Print Direction	Bidirectional with logic seeking
Noise Level	55 dB(A)
Emulation	ESC/P2, IBM PPDS
Interface	Parallel, USB