83
2. Select the Settings menu and press Enter.
3. Select the Lock Setting setting and press Enter.
4. Select one of these lock types and press Enter:
• To lock the projector's power button, select Child Lock. This setting is enabled once the projector
is turned off. To turn the projector on, you must press the projector's power button for longer than
three seconds.
Note: Child Lock does not prevent the projector from turning on when the power cord is
connected if the Direct Power On Setting is set to On.
• To lock all buttons, select Control Panel Lock > Full Lock. This setting is enabled once you exit
the configuration menu.
• To lock all buttons except the power button, select Control Panel Lock > Partial Lock. This
setting is enabled once you exit the configuration menu.
Note: The lock icon is displayed on the screen if any control panel buttons are pressed while
this setting is enabled.
You see a confirmation prompt.
5. Select Yes and press Enter.
Unlocking the Projector's Buttons
To Next Page
Loading...
Need help?
General