Epson M205 - Running a Product Check

Running a Product Check
Running a product check helps you determine if your product is operating properly.
1. Disconnect any interface cables connected to your product.
2. Load a few sheets of plain paper in the product.
3. Press the Ajustes button.
4. Press the up or down arrow buttons to select Maintenance and press the OK button.
You see this screen:
5. Press the up or down arrow buttons to select Nozzle Check and press the Iniciar button.
After the nozzle pattern prints, you see this screen:
6. Do the following, depending on the results of the product check:
• If the page prints and the nozzle check pattern is complete, the product is operating properly. Any
operation problem you may have could be caused by your computer, cable, software, or selected
settings. Check the other solutions in this book or try uninstalling and reinstalling your printer
software.
• If the page prints but the nozzle check pattern has gaps, clean or align the print head.
• If the page does not print, the product may have a problem. Check the other solutions in this
manual. If they do not work, contact Epson.
Parent topic: Solving Problems
Related concepts
Print Head Cleaning
144