4 - Mobilink P80 & Mobilink P80 Plus
Battery
* You can continue printing, but replacing or charging the battery is
recommended.
** Replace or charge the battery.
*** Replace or charge the battery. The printer is unable to print.
Buttons
Power
Press this button to turn the power on or off. To turn the
power off, hold the button for more than two seconds.
Feed
Press this button to advance the paper one line. Hold the
button down to advance the paper.
Changing the Paper Size
Note: The paper size can only be changed on the Mobilink P80 Plus.
To change the paper size from 3.15 inches (80 mm) to
3 inches (76 mm), do the following:
1. Turn the printer off.
2. Open the roll paper cover and remove any paper.
Note: When installing the paper guides, make sure that the metal
part of each guide is facing towards the inside of the printer.
3. Align the two tabs on the paper guide with the slots in the
bottom of the roll paper holder.
4. Firmly insert the metal part of the paper guide into the slot
at the front of the roll paper holder.
5. Repeat the above instructions for the other paper guide,
then load your paper and close the roll paper cover.
Loading Paper
Caution: To avoid injury, do not touch any part of the printer other
than the roll paper when the cover is open.
Note: Do not open the paper roll cover when the printer is printing
or feeding paper. Only use paper that meets specifications, and do
not use rolls that have the paper glued onto the core.
1. Open the roll paper cover by pressing down on the roll
paper cover open button.
2. Remove the used roll paper core, if there is one, and insert
the roll paper in the direction shown below.
Printer
condition Battery LED
Error
LED
Battery
charge status
Power on 3 LEDs on Off Level H
2 LEDs on Off Level M
Power on and
buzzer sounds
1 LED on Off Level L*
1 LED flashing On Level S**
3 LEDs off On Level E***
To Next Page
Loading...
