2 Plug In and Turn On
1 Connect the power adapter to the back of
PictureMate Pal.
2 Connect the power
cable to the power
adapter.
3 Plug the other end
of the power cable
into a power outlet.
4 Flip the handle to the back.
5 Open the paper support.
6 Press the On button to turn on PictureMate Pal.
After a moment, you see
this on the photo
viewer screen:
Now you can install your initial photo cartridge.
3 Install the Initial
Photo Cartridge
1 Open the cartridge door.
2 Slide the cartridge lever left
to the Release position.
3 Remove the initial photo cartridge
from its package.
Caution: Do not install a
different PictureMate Pal
cartridge for initial setup.
Install only the initial photo cartridge
that came with PictureMate Pal.
4 Slide the cartridge straight into the slot, label side up,
until it clicks into place. It will not go in all the way.
5 Slide the lever all the way right, to the Lock position.
Caution: If the cartridge is not inserted correctly,
ink may leak.
6 Close the cartridge door.
PictureMate Pal charges the print head for
3 to 4 minutes and displays the screen above.
7 When you see the
Charging complete
message on the photo
viewer screen, press OK.
Turn over
Initial Charge
Charging.
Please wait.
Start Here
Set up your PictureMate Pal
and print–no computer
required!
Note: To print from your computer, see
the Basics book and your CD after completing these steps.
1 Unpack
PictureMate Pal comes with all these items in the box.
1 Remove all the tape and packing material from the
outside of PictureMate Pal.
2 Open the cartridge door
on the back of
PictureMate Pal.
3 Remove the packing
material from inside the
cartridge slot.
4 Close the cartridge door.
PictureMate Pal
Initial PictureMate Pal
photo cartridge
PictureMate Pal
photo paper
Basics book
PictureMate Pal
Printer Software CD
Power adapter Power cable
PM 200
Press OK
To Next Page
Need help?
General
