Start Here
4
Load paper
1 Open the rear paper feed cover if necessary. Flip the
feeder guard forward and slide the edge guide to the right.
2 Load 4 x 6 or 5 x 7-inch photo paper, glossy or printable
side up and short edge first, against the left side.
3 Slide the edge guide against the paper, but not too tightly,
and flip the feeder guard back.
4 Press or to select Change on the LCD screen and
press the OK button.
5 Select your paper size and press the OK button.
6 Select your paper type and press the OK button.
7 Press the OK button again to confirm the paper settings.
Note: Make sure the paper settings matches the type and size of
paper you loaded.
Read these instructions before using your product.
1
Unpack
Note: Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials from the product.
Caution: Do not touch the flat white cable.
2
Turn on and configure
1 Connect the AC adapter to the back of the product. Then
connect one end of the power cord to the AC adapter and
the other end to an electrical outlet.
Caution: Do not connect to your computer yet.
2 Move the handle behind the printer, lower the output tray,
and open the printer cover.
3 Raise the control panel and turn on the product.
Note: If an error message appears, turn off the product and
check that no protective material has been left inside the product.
4 Press or to select your language, then press the OK
button.
Note: You can change the language later using the product’s
control panel. For more information, see the online User’s Guide.
3
Install ink cartridge
Caution: Keep ink cartridges out of the reach of children and don’t
drink the ink.
1 Unpack the initial ink cartridge and completely remove the
yellow tape only.
Caution: Do not remove any other labels or seals, or ink
may leak.
2 Remove the plastic base and carefully dispose of it.
Caution: Do not touch the areas on the ink cartridge shown
below. Doing so may prevent normal operation and printing.
Warning: If ink gets on your skin, wash it thoroughly with soap
and water. If ink gets into your eyes, flush them immediately with
water. If ink gets into your mouth, spit it out and see a doctor
right away.
3 Hold the cartridge with the green chip facing you and
insert the cartridge at an angle as shown. Press down the
ink cartridge until it clicks into place.
Caution: Make sure to insert the ink cartridge in the correct
direction or you may damage the product.
4 Close the printer cover.
5 Press the button to start charging the ink.
Ink charging takes a few minutes. Ink charging is
complete when you see the home screen displayed on the
LCD screen.
Caution: Do not turn off the product or open the printer cover
while the product is charging or you’ll waste ink.
Note:
• The printer is designed for use with Epson
®
cartridges only, not
third-party cartridges or ink.
• The cartridge included with the printer is designed for printer
set up and not for resale. After some ink is used for charging,
the rest is available for printing.
• If the screen is dark, the product has entered sleep mode.
Press any button on the control panel to wake the product.
You can adjust the sleep timer later if necessary. For details,
see the online User’s Guide.
PM-525
To Next Page
Need help?
General