INSTALLATION
HANDBOOK
Maintenance
Epson PowerLite 1220 / 1260
2
4. Loosen the two screws holding the lamp in place (you can’t
remove them).
5. Hold the lamp as shown and pull it straight out.
6. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.) Then tighten its screws.
Loosen, but don’t
remove these screws
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
7. Replace the lamp cover, then tighten its screw.
8. Reset the lamp timer as described in the next section.
note
Tighten the lamp cover
securely so you do not receive
a lamp cover error when you
turn the projector back on.
To Next Page
Loading...
Need help?
General