Epson PowerLite 1220 Installation Handbook

INSTALLATION
HANDBOOK
Maintenance
Epson PowerLite 1220 / 1260
3
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu system.
1. Press the
Menu button on the remote control or on the
projector’s control panel. You see the main menu.
2. Select the
Reset menu and press Enter. You see this screen:
3. Select
Reset Lamp Hours and press Enter.
4. When you see the prompt, select
Yes and press Enter.
5. When you’re finished, press
Menu to exit.
Checking Lamp Usage
To check the number of hours the lamp has been used, press the
Menu button and highlight the Info menu. You see a screen like this:
The life span of the lamp is about 4,000 hours if
Power
Consumption
in the Settings menu is Normal (default), and 5,000
hours if this setting is
ECO. Make sure you have a spare lamp handy if
the usage hours on this menu are close to the life span of your lamp.
note
The information displayed
depends on the input signal
currently selected.
If you have used the
projector for less than
10 hours, the hours are
listed as 0H.

Epson PowerLite 1220 Specifications

General

Brand	Epson
Model	PowerLite 1220
Category	Projector
Language	English