Setting Up the Projector 25
Connecting a Component Video Source
If your video equipment has component video connectors (three
connectors labeled either Y/Cb/Cr or Y/Pb/Pr), you can use the
component-to-VGA video adapter that came with your projector and
a component video cable, or you can purchase a component-to-VGA
video cable from Epson (see page 15) or an electronics dealer.
1. Connect one end of your component video cable to the Y/Cb/Cr
(or Y/Pb/Pr) connectors on your player.
2. Connect the component end of the component-to-VGA video
adapter to the free end of the component video cable.
3. Connect the VGA end of the adapter to the
Computer
(Component Video)
port on your projector.
4. You may need to change the
Input Signal setting in the
projector’s Signal menu to
Auto (see page 60).
5. If you want to play sound through the projector, see page 32 for
instructions on connecting an audio cable.
When you’ve finished making connections, see page 35 for
instructions on turning on the projector and Chapter 2 for
instructions on displaying and adjusting the image.
Computer (Component Video) port
To Next Page
Loading...
Need help?
General