Epson PowerLite 700 - Resetting the Lamp Timer

76 Maintaining the Projector
6. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.) Then tighten its screws.
7. Replace the lamp cover, then tighten its screw.
8. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu system.
1. Press the
Menu button on the remote control or on the
projector’s control panel. You see the main menu.
note
Tighten the lamp cover
securely so you do not receive
a lamp cover error when you
turn the projector back on.
note
Do not reset the lamp timer
if you have not replaced the
lamp. Otherwise, you will
receive incorrect lamp usage
information on the Info
menu; see page 77.