Epson PowerLite 700 - Starting the Projector with a Password

Fine-Tuning the Projector 65
5. Hold down the Num button and use the numeric keypad to enter
a four digit password.
6. When you see a confirmation message, reenter the password.
7. Press the
Menu button, then press Enter to exit the screen.
8. Turn off and unplug the projector.
Starting the Projector With a Password
When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the
Num button and use the numeric keypad to enter the
four digit password.
The password screen closes and projection begins.
Hold down
note
If you leave the projector
p
lugged in, the Password
screen will not appear. It
appears only if you unplug
and reconnect the power
cord.
Hold down