Power light Lamp light Temperature Status and solution
light
Red Off Red Projector has overheated and turned off. Leave it
turned off to cool down for five minutes.
• Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby
objects.
• If operating the projector at high altitude, turn on
High Altitude Mode.
• If overheating continues, replace the air filter.
• If the problem persists, unplug the projector and
contact Epson for help.
Red Flashing red Off Lamp has a problem.
• Check to see if the lamp is burned out, broken,
or installed incorrectly. Reseat or replace the
lamp as necessary.
• Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby
objects.
• If operating the projector at high altitude, turn on
High Altitude Mode.
• If the problem persists, unplug the projector and
contact Epson for help.
On Flashing Off Replace the lamp soon to avoid damage. Do not
orange continue using the projector.
Red Off Flashing red A fan or sensor has a problem. Turn the projector
off, unplug it, and contact Epson for help.
Red or flashing Flashing red Flashing red Internal projector error. Turn the projector off,
red unplug it, and contact Epson for help.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
144
To Next Page
Loading...
Need help?
General