Using the Projector on a Network
Follow the instructions in these sections to set up your projector for use on a network.
Wired Network Projection
Wireless Network Projection
Setting Up Projector Network E-Mail Alerts
Setting Up Monitoring Using SNMP
Controlling a Networked Projector Using a Web Browser
Crestron RoomView Support
Wired Network Projection
You can send images to your projector through a wired network (PowerLite 95/96W/905/915W/1835). To
do this, you connect the projector to your network, and then set up your projector and computer for
network projection.
Note: With the PowerLite 93, you can monitor projector operations over a wired network, but not project
images over the network.
After connecting and setting up the projector as described here, install the network software from the
Epson Projector Software for Meeting & Presentation CD-ROM on your computer. Use the following
software and documentation to set up, control, and monitor network projection:
• EasyMP Network Projection software sets up your computer for network projection (PowerLite
95/96W/905/915W/1835). See the EasyMP Network Projection Operation Guide installed from your
projector CD for instructions.
• EasyMP Monitor software (Windows only) lets you monitor and control your projector through the
network. You can download the latest software and documentation from the Epson web site. Go to
www.epson.com/support (U.S.) or www.epson.ca/support (Canada) and select your projector.
Connecting to a Wired Network
Selecting Wired Network Settings
Parent topic: Using the Projector on a Network
Connecting to a Wired Network
To connect the projector to a wired local area network (LAN), use a 100BaseTX or 10BaseT network
cable. To ensure proper data transmission, use a Category 5 shielded cable or better.
42
To Next Page
Loading...
Need help?
General