Epson PowerLite S4 Product Information

Epson PowerLite S4
6/06 Epson PowerLite S4 - 3
Positioning the Projector
You can install the projector for these viewing setups:
When projecting from a rear or overhead position, reorient the
image by changing the
Projection setting in the Extended
menu.
Image Size and Projection Distance
The maximum size of the image is determined by the distance
from the projector’s lens to the screen. Depending on how you
use the zoom and other settings, the actual size may be smaller.
To determine the exact image size when you know the
projection distance (or the exact projection distance when you
know the desired image size), you can use the Projection
Distance Calculator. You can download this program from the
Epson website at http://support.epson.com.
Turning the Projector On and Off
1. Open the lens cover.
2. Connect the power cord to the projector and plug the other
end into an electrical outlet.
3. The
Power light turns orange.
4. Press the
P Power button on the projector or remote
control.
You hear a beep, the
Power light flashes green, and the lamp
comes on in about 4 seconds. The
Power light stays green.
5. Start your video or presentation. If you have connected more
than one video source, use the
Source buttons on the
remote control to select the one you want to watch.
Turning Off the Projector
1. Press the P Power button on the projector or remote
control.
2. When you see the confirmation message, press the
P Power
button again.
3. When the projector beeps twice and
Power light turns
orange, unplug the projector.
Caution: Turn off this product when not in use to prolong the life
of the projector.
Projection distance
(wide to tele) Maximum diagonal image size
2.9 to 3.9 feet 30 inches (26 × 14 inches)
3.8 to 5.2 feet 40 inches (34 × 19 inches)
5.8 to 7.9 feet 60 inches (52 × 29 inches)
7.8 to 10.5 feet 80 inches (69 × 39 inches)
9.7 to 13.2 feet 100 inches (87 × 49 inches)
19.6 to 26.5 feet 200 inches (174 × 98 inches)
29.4 to 39.8 feet 300 inches (261 × 147 inches)
Front Rear
Front/ceiling
Rear/ceiling
AC power inlet

Epson PowerLite S4 Specifications

General

Number of colors	16.78 million colors
Projection distance	6 m
Vertical scan range	48 - 85 Hz
Horizontal scan range	15 - 92 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	30 - 300 \
Projector native resolution	SVGA (800x600)
Keystone correction, vertical	-30 - 30 °
Lamp type	UHE
Lamp power	170 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Focus	Manual
Focal length range	16.6 mm
Interface	USB
Audio input	RCA x 2
Dimensions (WxDxH)	246 x 328 x 100 mm
Power requirements	100-240 V +/- 10%, 50/60 Hz AC
Connectivity technology	Wired
Noise level	36 dB
Dot clock scanning frequency	162 MHz
RMS rated power	1 W
Number of built-in speakers	1
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)	5 W
Power consumption (typical)	250 W
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	2600 g