8
Adjust the projection size for the commander's frame
(white).
Select Quick Corner.Select Perform keystone
correction for the Receiver.
Use the commander's zoom ring
to adjust the commander's frame
(white) so that it is outside the
receiver's frame (green).
Use the [ ] [ ] [
] [ ]
buttons to correct the position of
the corners.
Correct each corner as necessary.
Press the [Esc] button to nish
making settings.
When you have nished making
corrections, press the [Esc]
button until you see the initial
adjustment screen again.
Use the [ ] [ ] [
] [ ]
buttons to select the corner you
want to correct, and then press
the [ ] button.
Use the [ ] [ ] buttons to
select the direction you want
to correct, and then press the
[ ] [ ] buttons to make
corrections.
Press the [Esc] button to nish
making settings.
When you have nished making
corrections, press the [Esc]
button until you see the initial
adjustment screen again.
Commander
frame
Receiver
frame
Select H/V-Keystone.
1616161616
For best results, minimize the
dierence in size between
the receiver's frame (green)
and the commander's frame
(white).
The images can still be
superimposed even if the
commander's frame is outside
the screen.
If you have trouble adjusting
the frames, make sure you
selected the correct screw hole
when you adjusted the angle
between the projectors. See
“Screen Size and Projection
Distance” on page 18 to
determine which screw hole
to use.
•
•
•
Correcting using
Quick Corner
Correct the four corners of the receiver's
frame (green) individually.
Correcting using
H/V-Keystone
Correct keystone distortion for the receiver's frame (green).
To Next Page
Loading...
