GPS Running Watch
Quick Start Guide
Buttons
1 Charging the Watch 2 Setting Up the Watch and App
17
Make sure to read the Notices sheet and online User’s Guide
before using the product to ensure safe use.
Back
Start/Stop
Up
Enter
Down
Use the included USB charging clip to charge
the watch.
1
Connect the USB charging clip to the watch.
2
Connect the USB cable to your PC or the
optional AC adapter.
Make sure the watch is fully charged before you
remove the clip.
The Settings screen appears on the watch after
you remove the USB charging clip.
1
On the watch, select your language and
press Enter.
2
Select Set by Phone and press Enter.
Note: You can also use a PC to congure the
watch or you can congure the watch on
its own. See the online User’s Guide for more
information.
3
Download and install the Epson View app
from your smartphone’s app store.
4
Launch the Epson View app and create
an account or log in. After you nish this
process, the initial Settings screen appears
on your smartphone.
3 Using Your Watch
Selecting a Workout Mode
1
Press down on the Time screen to display
the workout mode screen.
Note: You can press Start/Stop on the
Time screen to quickly start a run.
2
Press up or down to select the
desired activity.
The following workout modes are available:
Run Walk Treadmill
3
Press Start/Stop while outdoors with no
obstacles overhead to start GPS calibration.
You can start your workout when the
Measurement screen appears.
For increased GPS accuracy, wait at least 15
minutes before starting your workout. You
only need to perform this extended GPS
calibration the rst time you use the watch
or if you do not use it for a few months.
Note: If you see the message below, do one
of the following:
• Move to an area with no obstructions
overhead and then press back to
restart GPS calibration.
• Press Enter to start the workout.
Distance traveled will be estimated until
the GPS signal is fully acquired.
Starting a Workout
Press Start/Stop on the Measurement
screen to start a workout.
Note: You can press Enter during a
workout to start and record a new lap.
Press up or down during a workout to
change the measurements that appear. See
the online User’s Guide for more information.
5
Note the code that appears on the watch.
6
Select ProSense 17 from the list on your
smartphone, then follow the instructions to
pair your watch and your phone.
The Time screen appears on the watch when
the process is complete.
Note: You can pair the watch with your
smartphone at any time by selecting My
Watch in the Epson View app.
To Next Page
Need help?
General
