F
Keep the d button in the control panel pressed
until you have fed enough paper for about three
wraps around the roll core.
G
Keep the Manual switch pressed to Forward to
wrap the paper three times around the core.
After wrapping the paper around the core,
ensure that paper around the core is sufficiently
loose.
Note:
If the paper cannot be taken up evenly, use the
tensioner included with the auto take-up reel unit.
Slacken the paper and insert the tensioner near the
center of the paper as shown.
If conditions do not improve, use a roll core with the
same width as the loaded paper in place of the
tensioner.
H
Set the Auto switch to Forward.
Taking Up the Paper Printable Side In
For information on installing the roll core, see the Setup
Guide for the optional auto take-up reel unit.
Buttons that are used in the following settings
SC-B6000 Series User’s Guide
Basic Operations
31
To Next Page
Loading...
Need help?
General
