A
Set the auto take-up reel unit Auto switch to Off.
Plug the power cord into an outlet and confirm
that the power lamp lights.
B
Turn on the printer by pressing the P button.
C
Check that the roll paper is correctly loaded in the
printer.
D
Press the ) button on the control panel. Keep
the d button pressed until the end of the roll
reaches the roll core.
E
Tape the end to the roll core.
Place tape (available from third-party suppliers)
at the center and then at the left and right ends.
F
Keep the d button in the control panel pressed
until you have fed enough paper for about three
wraps around the roll core.
G
Keep the Manual switch pressed to Backward to
wrap the paper three times around the core.
After wrapping the paper around the core,
ensure that paper around the core is sufficiently
loose.
H
Set the Auto switch to Backward.
SC-B6000 Series User’s Guide
Basic Operations
32
To Next Page
Loading...
Need help?
General
