E
Attach the chip unit supplied with the new ink
pack to the slider.
Check to confirm that the color of the label on the
slider matches the color of the label on the chip
unit when installing.
F
Hold the slider level horizontally and insert it.
Close the side cover.
c
Important:
Do not push the slider in with too much force.
Failure to observe this precaution could
damage the printer.
G
Open the slider ink inlet cover.
H
Remove the ink inlet cap from the ink tank.
I
Tear off the ink pack spout opening.
SC-B6000 Series User’s Guide
Maintenance
57
To Next Page
Loading...
