Notes on Handling
!
Warning
Do not use the printer in locations with volatile substances such as alcohol or thinner, or near
naked ames.
An electric shock or re could occur.
Do not use the printer if it is giving o smoke or if you notice any abnormal odors or noises.
An electric shock or re could occur. If any abnormalities occur, turn o the power and unplug the
power cable immediately, and then contact your dealer or Epson Support.
Never try to repair the printer yourself as this is extremely dangerous.
Do not use the printer in an environment where ammable gas or explosive gas may exist. Do
not use sprays that contain ammable gas inside or near the product.
A re could occur.
Only route the cables as indicated in the manual.
A re could occur. This could also cause damage to connected devices.
Do not insert or drop any metallic or ammable items into the openings on the printer.
An electric shock or re could occur.
Do not touch any areas inside the printer except for those indicated in the manual.
An electric shock or burn could occur.
Do not disassemble anything except when indicated to do so in the manual.
If the LCD for the control panel is damaged, be careful of any leaking liquid crystal.
Provide rst aid under any of the following conditions.
❏
If liquid adheres to your skin, immediately wipe it off and then wash the area using large
volumes of soapy water.
❏
If any liquid gets in your eyes, ush them with clean water for at least 15 minutes, and consult a
physician immediately.
❏
If liquid is swallowed, rinse your mouth out with water, swallow large quantities of water and
vomit it back up, and consult a physician immediately.
If any foreign objects or liquid such as water enters the printer, stop using it immediately.
An electric shock or re could occur. Turn o the power and unplug the power cable immediately,
and then contact your dealer or Epson Support.
!
Caution
Do not sit on the product or place any heavy objects on the product.
The printer could tip over or break and cause an injury.
When transporting or storing the product, be sure that it is level: do not tilt it at an angle or
place it upside down.
Ink could leak.
Be careful not to trap your hands or fingers when opening or closing the printer covers or
maintenance cover.
Failure to observe this precaution could result in injury.
Do not put your hands inside any of the openings on the printer.
Your hands could be injured if they are caught in moving parts.
Do not put your hands on the movable base.
Your hands could be injured if they are caught in moving parts.
When connecting cables or optional accessories, make sure they are installed in the correct
direction and that you follow the procedures exactly.
A fire or an injury could occur. Install the printer correctly by following the instructions in the
manual.
When moving the product, make sure it is turned o, the power cable is unplugged from the
outlet, and all connecting cables have been removed.
If cables are damaged, an electric shock or re could occur.
Except when moving the product, keep all casters on the stand and ink unit locked at all times.
Failure to observe this precaution could cause accidents.
If you opened the printer cover in operation, do not touch the area as indicated by the warning
labels.
High temperatures may cause burns.
Notes on the Power Supply
!
Warning
Make sure the blades on the plug are inserted completely into the power outlet.
An electric shock or re could occur.
Unplug the plug regularly and clean between the blades and around the base of the blades.
If the plug is plugged in for an extended period of time, dust collects around the base of the blades
and a short circuit or re could occur.
When unplugging the plug, grip the plug itself; do not pull the power cable.
If the cable is damaged or the plug is deformed, an electric shock or re could occur.
Do not insert or unplug the plug with wet hands.
An electric shock could occur.
EN Important Safety Instructions
6
To Next Page
Loading...
Need help?
General