EpsonEngineeringEurope SC‐S30600/610TechnicalGuide Page|8
STEPAMEDIASELECTION
Note:thissectionwillgivedetailedexplanationforeachsettingswithimportanteffectonquality
A1MediaSelection
JustafterloweredthePaperPressureLever,theprinterwill displaythesettingsyoucanuseforthemediapreviously
loaded.If youhave alreadycreated a custom Media and wantto useit, thenselect [ChangeSettings]to selectthe
correctmediaorselect[RIPSettings].
A2Whattouse:RIPSettingsorCustomPaperxx?
EachtimeyouloadamediaRoll,theprinterwillpromptamessagetoselectthemediaType.Youhave2possibilities:
choosingRIPsettingsor.selectaCustomPaperxx.
●BychoosingRIPsettings,youdecidetomanageallmediasettingsandqualitysettingsFROMtheRIP.Theimage
andmediasettingspreviouslysetintheRIPsoftwarewillbesenttotheprinter.
●BychoosingaCustomPaperxx,youdecidethattheprintermanagesallmediasettings.TheRIPwillsendonly
theprintjobandtheresolutionchosenintheRIPsoftware.
STEPBCustomizing[RIPSettings]
Note:[RIPSettings]willapplyallthefollowingsettingsforanytypeofmedialoadedandused
B1.PlatenGap
The platen gap is the gap between the print head surface and the media and not the Media and the print head.
Depending onthe media thickness, set the correct platen gap to avoidhead strike.On SC‐S30600/610, youcan set
thegapfrom1.5(stdvalue)to
2.5.Forallmedia,theplatengapwillhaveanimportanteffectonprintquality.
Tips:Ifyouwishtooptimisetheoutputquality,trytouseotherplatengapsettings.
!Information
RemainingSetup:ON
SelectMedia
0RIPSettings
●KeepSengsAb ov e
●ChangeSengs
[OK]Proceed
SelectMedia:
●RIPSengs
●Media1
●Media2
●Media3
●etc upto30
[OK]Proceed
RIPSettings:
●PlatenGap(1,5,2,2,5)
●HeadAlignmen t
●RollType(SideIn,SideOu t )
●TensionMeasurement
●MediaTension