B
Press the d button in the control panel to feed
enough media for a single wrap around the roll
core.
C
Flip the Auto switch to Off, and hold down the
Manual switch to
to wrap the media once
around the roll core.
D
Flip the Auto switch to .
E
Lower the tension bar until it slightly touches the
media.
F
Confirm that the media is attached without
looseness.
If the tension on the left and right of the media is
different in the areas shown in the illustration
below, the media will not be taken up correctly.
When one side is loose, restart the procedure
from Step 1.
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Basic Operations
43
To Next Page
Loading...
Need help?
General