Epson Stylus CX9300 - Placing the Originals

10 Handling Paper and Originals
c Caution:
Do not use the following documents as they can
cause paper jams. For these kind of documents
you can use the document table.
❏ Documents held together with paper clips,
staples, and so on.
❏ Documents that have tape or paper stuck to
them.
❏ Photos, OHPs, or thermal transfer paper.
❏ Paper with a coated surface.
❏ Paper that is torn, wrinkled, or has holes.
Note:
When you use the copy function with the
automatic document feeder, the print settings
are fixed at zoom - 100%, paper type - Plain
Paper, and Paper Size - A4. The print out is
cropped if you copy an original larger than A4.
Placing the originals
Note:
❏ In Fax mode and Copy mode, the ADF icon is
displayed on the left of the LCD screen as
follows when there is a document in the
automatic document feeder.
❏ When there is a document in the automatic
document feeder and on the document table,
priority is given to the document in the
automatic document feeder.
1. Tap the originals on a flat surface to even
the edges.
2. Slide the edge guide on the automatic
document feeder.
3. Insert the originals face-up and short
edge first into the automatic document
feeder.
4. Slide the edge guide until it is flush with
the originals.
Capacity 30 sheets or 3 mm (A4, Letter)/
10 sheets (Legal)