8
Adjusting the Angle of the Panel
To lower or close the panel, unlock by pulling the lever on the rear until it
clicks, and then lower down. Simply lift the panel to raise it.
Power Saving Function
After 13 minutes of inactivity, the screen turns black to save energy.
Press any button (except P On) to return the screen to its previous state.
Restarting Automatically after a Power Failure
If the power supply fails while the
printer is in fax standby mode or
printing, it restarts automatically
when the power is reconnected. The
printer beeps for about two seconds.
Do not put your hand inside
the printer until the print head
stopped moving.
c
Depending on the circumstances
before the power failure occurred,
it may not restart. In this case, you
can restart by pressing P On.
Q
Restart is stopped if any of the
buttons on the control panel are
pressed before the LCD turns on.
Q
To Next Page
Loading...
