Epson Stylus Photo 2100 - Page 178

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 178
4.2.15.1 Reinstalling the PF Scale
This section explains the procedure for reinstalling the following parts.
" PF Scale (Loop Scale)
" Scale Mounting Plate
" D50 Tape (double-faced tape)
1. Apply the D50 Tape to the PF Scale.
Figure 4-129. Peeling the Protective Sheet
2. After matching the round holes of the PF Scale with the projections of the Spur
Gear 76, insert the PF Scale so that it is in parallel with the Spur Gear 76. At this
point, do not apply the PF Scale to the Spur Gear 76.
3. Using the PF Scale Mounting Jig (AS-Tool No. 1051767), apply the PF Scale to
the Spur Gear 76.
Figure 4-130. Applying the PF Scale
C A U T I O N
The D50 Tape should match the outline of the printed circle.
Refer to Figure 4-129, "Peeling the Protective Sheet".
PF Scale
D50 Tape
Loop Scale Assembly
fitting jig
Tool No.#F730
C A U T I O N
When applying the PF Scale to the Spur Gear 76, slowly apply it so
that its inner diameter is not damaged.
If the inner diameter of the PF Scale is scratched and the PF Scale
become eccentric, the paper loading accuracy will decline.
Refer to Figure 4-130, "Applying the PF Scale".
Spur Gear 76
PF Scale Mounting Jig
Tool No.1051767
PF Scale
Projections