Epson Stylus Photo 2100 - Page 219

EPSON Stylus PHOTO 2100/2200 Revision B
MAINTENANCE Overview 219
11
! <Lubrication Point>
Hook of Paper guide lower
! <Lubrication Type>
G-45
! <Lubrication Amount>
φ1mm x 1mm x 4 points
Refer to Figure 6-9.
12
! <Lubrication Point>
Hook that engages the Paper eject roller shaft B
and Paper guide lower.
! <Lubrication Type>
G-45
! <Lubrication Amount>
φ1mm x 2mm x 5 points
Refer to Figure 6-10.
13
! <Lubrication Point>
Groove of Release lever shaft
! <Lubrication Type>
G-26
! <Lubrication Amount>
φ1mm x 10mm x 2 points
Refer to Figure 6-11.
! <Lubrication Point>
Hook of Frame upper that engages with the
Release lever shaft (3 places)
! <Lubrication Type>
G-26
! <Lubrication Amount>
φ1mm x 10mm x 2 points
Refer to Figure 6-11.
Table 6-2. Lubrication Points
Ref.
No.
Lubrication Type/Point Remarks
14
! <Lubrication Point>
5 places of Paper guide front
! <Lubrication Type>
G-26
! <Lubrication Amount>
1) φ1mm x 2mm x 4 points:
Paper eject roller side
2) φ1mm x 10mm x 1 point:
PF roller assembly side
Do not apply grease to the
rubber rollers of the Paper
eject rollers.
Refer to Figure 6-12.
15
! <Lubrication Point>
Shaft of Combination gear lever Assy
! <Lubrication Type>
G-26
! <Lubrication Amount>
φ1mm x 4mm
Use a brush to apply it.
Refer to Figure 6-13.
16
! <Lubrication Point>
Oil pad
! <Lubrication Type>
O-12
! <Lubrication Amount>
0.655cc
! Lubricate only at the
following timings.
• Replacement of
Carriage unit
• Replacement of Oil pad
! Use a dispenser to
lubricate. If much oil
is applied, dispose of
that pad and lubricate
a new pad.
! After lubrication,
leave the pad to stand
for 1 minute, and
mount it to the
Carriage unit with the
lubricated surface
located on the CR
guide shaft side.
Refer to Figure 6-14.
Table 6-2. Lubrication Points
Ref.
No.
Lubrication Type/Point Remarks