Epson Stylus Photo 2100 - Page 220

EPSON Stylus PHOTO 2100/2200 Revision B
MAINTENANCE Overview 220
16
! <Lubrication Point>
Oil pad ring
! <Lubrication Type>
O-12
! <Lubrication Amount>
0.22cc
! Lubricate only at the
following timings.
• Replacement of
Carriage unit
• Replacement of Oil
pad ring
! Pour the specified oil
in a clean pan-shaped
vessel and immerse
the pad there for 1
minute.
! After lubrication,
leave the pad ring to
stand for 1 minute, and
mount it to the
carriage unit with the
lubricated surface
located on the CR
guide shaft side.
Refer to Figure 6-14.
17
! <Lubrication Point>
Feed roller assembly mounting hole in the right
side of the ASF frame
! <Lubrication Type>
G-26
! <Lubrication Amount>
Entire periphery of inside diameter
Refer to Figure 6-15.
! <Lubrication Point>
Portion that slides with the Release hopper lever
of the Hopper assembly (2 places)
! <Lubrication Type>
G-26
! <Lubrication Amount>
φ1mm x 10mm x 2 points
Refer to Figure 6-15.
Table 6-2. Lubrication Points
Ref.
No.
Lubrication Type/Point Remarks
18
! <Lubrication Point>
PG change spring lever mounting hole outside
diameter
! <Lubrication Type>
G-26
! <Lubrication Amount>
φ1mm x entire periphery of outside diameter
Place the adjust lever in the
far side position and apply
grease.
Refer to Figure 6-16.
19
! <Lubrication Point>
Tooth surfaces of Release levers and Release
connection lever
! <Lubrication Type>
G-26
! <Lubrication Amount>
1) Release connection lever:
φ1mm x entire periphery of tooth surface
2) Release lever (front side):
φ1mm x 3/4 tooth surface
3) Release lever (far side):
φ1mm x 10mm
Place the Release levers in
the front and far side
positions and apply grease.
Refer to Figure 6-17.
20
! <Lubrication Point>
Combination gear 17, 24.5 bearing
! <Lubrication Type>
G-26
! <Lubrication Amount>
φ1mm x 5mm
Refer to Figure 6-18.
21
! <Lubrication Point>
Holes of left parallelism adjust bush and sub-left
parallelism adjust bush
! <Lubrication Type>
G-26
! <Lubrication Amount>
Entire periphery of inside diameter
Apply grease to the entire
periphery.
Refer to Figure 6-19.
Table 6-2. Lubrication Points
Ref.
No.
Lubrication Type/Point Remarks