EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 81
At operation Operation at power-on is normal,
but the error appears when the
print jog is sent to the printer.
IEEE1394 1. Check that the same code as the IEEE1394 QR label code is
saved at D4<H> to D8<H> of the EEPROM.
1. Input the code given as the IEEE1394 QR
label code.
Printer driver 1. Check that the Stylus PHOTO 2100/2200 printer driver has been
installed.
2. Check that the connected printer is the Stylus PHOTO 2100/2200.
1. Install the Stylus PHOTO 2100/2200 printer
driver.
2. Connect the Stylus PHOTO 2100/2200 printer.
Main board 1. Check that a wrong model name has not been input to the
EEPROM address, E0<H>, on the Main board.
1. Using the adjustment program, enter the
correct model name (save 02 into E0<H>).
Table 3-3. "Phenomenon-Based Communication Error Check Points"
Occurrence Timing Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
Label code
To Next Page
Loading...
