Epson Stylus Photo - Ink Jet Printer - Mechanical, Electrical, and Interface Specs; Mechanical Details; Electrical and Environmental; Interface Specifications

EPSON Stylus Photo
4 - EPSON Stylus Photo
3/97
Mechanical
Paper feed method
Friction
Paper path
Sheet feeder, rear entry
Sheet feeder capacity
100 sheets at 17 lb (64 g/m
2
) paper
Dimensions
Storage
Width: 16.9 inches (429 mm)
Depth: 10.8 inches (275 mm)
Height: 6.6 inches (168 mm)
Printing
Width: 16.9 inches (429 mm)
Depth: 24.1 inches (613 mm)
27.4 inches (695 mm) when printing
transparencies
Height: 12.2 inches (309 mm)
7.7 inches (196 mm) when printing
transparencies
Weight
11.5 pounds (5.2 kg) without the ink cartridges
Electrical
Note
:
Check the label on the back of the printer for the voltage rating
of your printer.
Environmental
Temperature
Operation: 50 to 95 °F (10 to 35 °C)
Storage:
–
4 to 140 °F (
–
20 to 60 °C), stored in
shipping container
1 month at 104 °F (40 °C)
120 hours at 140 °F (60 °C)
Humidity
Operation: 20 to 80% RH (without condensation)
Storage: 5 to 85% RH (stored in shipping
container, without condensation)
Safety Approvals
Safety standards
UL 1950 with D3, CSA C22.2 No.950 with D3
EMC
FCC part 15 subpart B class B, CSA C108.8 class B
Interface
Your printer is equipped with an 8-bit parallel interface and
a Macintosh
®
serial interface.
Parallel interface
The built-in parallel interface has the following
characteristics:
Forward channel
Data format: 8-bit parallel, IEEE-1284 compatibility mode
Synchronization:
STROBE
pulse
Handshake timing: BUSY and
ACKNLG
signals
Signal level: TTL compatible
Connector: 57-30360 Amphenol connector or equivalent
Reverse channel
Transmission mode: IEEE-1284 Nibble mode
Adaptable connector: 57-30360 Amphenol Connector or
equivalent
Synchronization: Refer to the IEEE-1284 specification
Handshaking: Refer to the IEEE-1284 specification
Signal level: IEEE-1284 Level 1 device
Data transmission timing: Refer to the IEEE-1284
specification
Serial interface
The printer’s built-in serial interface is based on the RS-423
standard. This interface has the following characteristics:
Standard: Based on RS-423
Synchronization: Synchronous
Bit rate: Approx. 900 Kbps
Handshaking: X-ON/X-OFF, DTR protocol
Specification
120V Model 220-240V Model
Input voltage range 103.5 to 132V 198 to 264V
Rated frequency range 50 to 60 Hz
Input frequency range 49.5 to 60.5 Hz
Rated current 0.4A 0.2A
Power consumption Approx. 15W (ISO/IEC 10561 Letter Pattern)