4.2.2
Removing the Housing
4.2.2.1
ADF Unit (Artisan 800/PX800FW/TX800FW only)
Parts/Components need to be removed in advance:
None
Removal procedure
1.
Open the Scanner Unit.
2.
Cut the harness cover clamp with a nipper as shown in Fig. 4-3 and remove the
harness cover clamp.
3.
Slide the Cable Cover to the rear of the printer by pushing the point A of the
Cable Cover to release the hooks (x4) and ribs (x2), and remove the Cable
Cover.
Figure 4-3. Removing the Cable Cover
4.
Disconnect the ADF Motor Cable and ADF Sensor Cable from the connectors
on the Main Board. (See Fig. 4-4.)
5.
Pull out the terminal of the Grounding Wire from the fixing rib of the frame.
Figure 4-4. Removing the ADF Unit (1)
The harness cover clamp needs to be cut when removing, and
cannot be reused. When installing the Cable Cover, replace it with a
new one.
Figure 4-2. Damaged stopper
To Next Page
Loading...
