5.2.5
PF Adjustment
PF-Standard Area
Patterns are printed as shown below.
PF-Bottom Edge Area
Patterns are printed as shown below.
Upper block
1
2 3 4 5 6 7 8
-1
Lower block
Figure 5-7. PF Adjustment (Bottom Edge Area) Pattern
1
How to Judge
2
3
Input the value shown above the patterns which has no gap between the upper pattern
and the lower pattern, and also the both upper and lower patterns do not overlap each
other.
How to Judge
Figure 5-6. PF Adjustment (Standard Area) Pattern
Example: In the above figure, patterns below “ 4” has no gap and overlap, so input “ 4” .
Additional information
Enter the value for the group that has no gap or overlap between the upper and the
lower patterns.
In case that all patterns have gap or overlap, select the value for the pattern which has
the least gap or overlap, and print the pattern again.
To Next Page
Loading...
