Epson Stylus Photo R1900 - Page 82

EPSON Stylus Photo R1900/R2880/R2000 Revision E
Disassembly And Assembly Removing the Housings 82
Confidential
REMOVING THE PRINTER COVER
1. Remove the Upper Housing / Printer Cover. (p.81)
2. Remove the two C.B.P. M3 x 10 screws that secure Printer Cover Holder Left/
Right.
Figure 4-20. Removing the Printer Cover Holder Left/Right
3. Remove the Printer Cover Holder Right following the steps below.
3-1. Open the Printer Cover and place the Upper Housing with its backside
down.
3-2. Pull the Printer Cover in the direction of the red arrow so as to prevent the
parts of the Printer Cover Holder Right and Upper Housing shown below
from interfering.
Figure 4-21. Removing the Printer Cover (1)
Insert the tabs (two each on the left/right) shown in Figure 4-20 into
the holes on the Upper Housing.
Tabs
Tabs
1) C.B.P. M3x10
(6±1 kgf.cm)
1) C.B.P. M3x10
(6±1 kgf.cm)
Upper Housing
Printer Cover Holder Right
Printer Cover Holder Left
C A U T I O N
Be careful not to damage the surface in step 3 and later.
Printer Cover Holder Right
Printer Cover
Upper Housing
Interfering Parts of Printer Cover Holder
Right and Upper Housing.
interfering part
Tab