32 Maintaining Your Printer
4. When the green P power light stops flashing, make sure paper is loaded in the
printer, then do one of the following:
■ Windows: Click Print nozzle check pattern, then click Print.
■ Macintosh: Click Confirmation, then click Next.
The nozzle check pattern prints.
5. If the nozzle check pattern has no white lines or gaps (as shown below),
click
Finish.
If the pattern has white lines or gaps (as shown below), click
Clean to clean
the print head again.
If you don’t see any improvement after cleaning three or four times, refer to
“Problems and Solutions” on page 46.
You can also turn the printer off and wait overnight—this allows any dried ink
to soften—and then try cleaning the print head again.
R220.book Page 32 Sunday, August 7, 2005 3:41 PM
To Next Page
Loading...
