10 Handling a CD/DVD
Ejecting the CD/DVD Tray
1. Make sure that printing is finished.
2. Eject the CD/DVD tray by pulling it straight out
of the front tray.
3. Move the tray lever up to reposition the front
tray.
Adjusting the Print Position
If your printed image is not centered on the
CD/DVD, you can adjust its printing position.
1. If necessary, print a test sample using an extra
CD/DVD.
2. Press the F [Setup] button.
3. Use the l or r button to select the Print Position,
and press OK to enter this mode.
4. Use the u or d button to select CD/DVD.
5. Press the r button, you see a screen like this:
6. Use the u or d button to adjust the Up-Down
print position, and use the l or r button to adjust
the Left-Right print position.
7. Press the OK button to apply the new setting.
Note:
This product retains your settings even after it has been
turned off, so you do not need to readjust the printing position
each time you print a CD/DVD.
Options Description
Up-Down Move the CD/DVD print position up or
down. You can adjust it by 0.1 mm from
-2 to +2 mm.
Left-Right Move the CD/DVD print position left or
right. You can adjust it by 0.1 mm from
-2 to +2 mm.
1. Move the CD/DVD up
2. Move the CD/DVD right
3. Move the CD/DVD down
4. Move the CD/DVD left
To Next Page
Loading...
