Epson Stylus Pro 10000 - Page 16

Installing Command WorkStation | 13
Configuring Command Workstation
1. If Command WorkStation is open, click
OK
.
Otherwise, go to
Start
>
Programs
>
Command WorkStation
, then
click
Command WorkStation
.
2. Enter the appropriate information for the Fiery Spark, then click
Add
:
3. Make sure the printer name is selected in the Devices list, then click
OK
.
4. Select the printer name in the list
of Available Servers, then click
OK
.
enter PRO10K for the
Stylus Pro 10000 (dye
ink), PRO10KCF for
the Stylus Pro 10000
(pigment ink), or
PRO5500 for the
Stylus Pro 5500
the Nickname can be
different from the Fiery
Spark server name, but
cannot contain
[ ] _ " ' <space> <tab>
This example uses
EPSON as the
nickname.
enter the IP address or
server name of the
Fiery Spark
click Add